
Stainless Steel
Oval Covered Serving Dish
A deep oval dish with a domed lift-off lid, set on a wide flat rim that runs out into a flat tab handle at each end. Mirror-polished inside and out.
In use
It travels a corridor, a lift and a threshold.
In-room dining is the only service where the metalware is carried further than it is looked at. Non-slip surfaces and a cloche that seals are worth more here than any decorative detail.
The scenario
A 180-key hotel running in-room dining from a single kitchen floor.
What to specify
The pieces

Stainless Steel
A deep oval dish with a domed lift-off lid, set on a wide flat rim that runs out into a flat tab handle at each end. Mirror-polished inside and out.

Stainless Steel
A rectangular tray with a smooth rolled rim and a recessed centre panel worked in a regular beaded pattern. Made in two sizes.

Stainless Steel
A rectangular hand-hammered tray whose short ends draw out into shaped handles cut from the same sheet, with a raised rim on all four sides.

Stainless Steel
Three graduated oval trays, hammered across the well, with a plain rolled rim. They nest.

Stainless Steel
A flat serving tray with a wide hammered rim framing a smooth mirror well, made as two ovals and a round.

Stainless Steel
A rectangular hammered tray with a slot cut into the raised rim at each end to serve as a handle. Made in two sizes.

Stainless Steel
A small narrow tray with a rolled rim and a recessed panel, photographed in two surface treatments — a fine bead and an etched scroll.

Stainless Steel
A rectangular tray with a hammered floor inside a wide smooth rolled rim, corners drawn up and softened.

Stainless Steel
A deep oval dish with a domed hammered lid seated on a wide flat rim, the base left smooth.

Stainless Steel
A square covered dish, hammered on both base and lid, with a fine beaded moulding running around the rim of each.
Stainless Steel
A 20-inch gallery-rim tray with cast side handles, sized to carry a full in-room dining cover in one trip.
Stainless Steel
A 12-inch round with a bonded rubber deck. The most-replaced item behind any bar, built to stop being replaced.
Brass
A spun brass cloche with a matching tray. Used for the reveal at the table and for the carry down a corridor.
Stainless Steel
A 500 ml sauce boat with a drip-free lip and an underplate. It pours clean or it is not finished.
Stainless Steel
Two 2.5-litre wells under one lid. The condiment and side-dish workhorse of a breakfast counter.
Stainless Steel
A 1.5-litre bar bucket with a perforated drain insert and matching tongs. Melt water sits below the ice, not in it.
Brass
A traditional gallery tray with a pierced and embossed rim, for lobby, turndown and welcome service.
Three hundred covers, one line, no cold food.
The metal a guest touches before the food arrives.
Sun, chlorine and salt air are a materials problem.
Trade enquiry
Tell us what you are specifying and we will come back with prices, MOQs and a lead time. If you already built an enquiry list, it is attached automatically.