
Stainless Steel
Square Tray, Hammered Rim
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.
Balanced in the hand before it is beautiful on the table.
A tray is judged by a server carrying it one-handed across a full room. We set the handle height and the rim angle for that, then hammer the face for the light.
How to specify
Hand-hammered faces hide scuffing far better than mirror-polished ones — the single most useful thing to know when buying for daily service.

Stainless Steel
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.

Stainless Steel
A rectangular tray with a smooth rolled rim and a recessed centre panel worked in a regular beaded pattern. Made in two sizes.

Stainless Steel
A narrow, fully hand-hammered tray with raised long sides and flat open ends, for canapés, breads and a run of small plates. Made in three graduated lengths.

Stainless Steel
A rectangular hand-hammered tray whose short ends draw out into shaped handles cut from the same sheet, with a raised rim on all four sides.

Stainless Steel
A long, narrow dish drawn to a point at one end and swept into a curved tail handle at the other, mirror-polished throughout. Made in two lengths.

Stainless Steel
Three graduated oval trays, hammered across the well, with a plain rolled rim. They nest.

Stainless Steel
Three graduated rectangular trays, hammered throughout, with a raised rim on all four sides and the corners drawn up.

Stainless Steel
A flat serving tray with a wide hammered rim framing a smooth mirror well, made as two ovals and a round.

Stainless Steel
A rectangular hammered tray with a slot cut into the raised rim at each end to serve as a handle. Made in two sizes.

Stainless Steel
A round dish and an oval platter with upswept hammered sides and a smooth mirror floor, deeper than a flat tray.

Stainless Steel
A square tray worked the other way round from most: a hammered centre panel inside a smooth stepped rim.

Stainless Steel
A small narrow tray with a rolled rim and a recessed panel, photographed in two surface treatments — a fine bead and an etched scroll.

Stainless Steel
A plain round platter, mirror-polished, with a narrow rolled rim and no texture anywhere on it.

Stainless Steel
A square tray with a hammered floor and a smooth rolled rim, the corners softened. Photographed as two sizes.

Stainless Steel
A rectangular tray with a hammered floor inside a wide smooth rolled rim, corners drawn up and softened.

Stainless Steel
A large square tray, hammered across the floor, with a smooth rolled rim and softened corners.

Copper
A square tray in hammered copper with a smooth rolled rim — the one piece in this set that is not silver-coloured.
Brass
A 14-inch hand-hammered round with a rolled rim. The general-purpose tray a floor uses forty times a day.
Stainless Steel
A 20-inch gallery-rim tray with cast side handles, sized to carry a full in-room dining cover in one trip.
Copper
An 18-inch oval for a whole roast, a whole fish, or a mezze spread. Steel-faced, copper-backed.
Brass
A traditional gallery tray with a pierced and embossed rim, for lobby, turndown and welcome service.
Stainless Steel
A 12-inch round with a bonded rubber deck. The most-replaced item behind any bar, built to stop being replaced.
Where it goes
Trade enquiry
Tell us what you are specifying and we will come back with prices, MOQs and a lead time. If you already built an enquiry list, it is attached automatically.