
Stainless Steel
Square Tray, Hammered Rim
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.
In use
Metal under low light, handled all night.
Bar metal is handled more than any other category in a hotel, by wet hands, at speed. It is also the most visible: a shaker is worked at eye level, eighteen inches from a paying guest.
The scenario
A 40-seat hotel lounge bar, low warm light, cocktail-led programme.
What to specify
The pieces

Stainless Steel
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.

Stainless Steel
A rectangular tray with a smooth rolled rim and a recessed centre panel worked in a regular beaded pattern. Made in two sizes.

Stainless Steel
A narrow, fully hand-hammered tray with raised long sides and flat open ends, for canapés, breads and a run of small plates. Made in three graduated lengths.

Stainless Steel
A long, narrow dish drawn to a point at one end and swept into a curved tail handle at the other, mirror-polished throughout. Made in two lengths.

Stainless Steel
Three graduated rectangular trays, hammered throughout, with a raised rim on all four sides and the corners drawn up.

Stainless Steel
A square tray worked the other way round from most: a hammered centre panel inside a smooth stepped rim.

Stainless Steel
A small narrow tray with a rolled rim and a recessed panel, photographed in two surface treatments — a fine bead and an etched scroll.

Copper
A square tray in hammered copper with a smooth rolled rim — the one piece in this set that is not silver-coloured.

Stainless Steel
A shallow leaf-shaped dish with a raised midrib running its length and a fine combed rib radiating from it. Made in two sizes.

Stainless Steel
A shallow triangular dish with a textured well and a smooth raised edge, the corners rounded. Made in two sizes.

Stainless Steel
A tapered ice bucket, hammered over the body, with a dropped ring handle on each side and a rolled rim.
Copper
A three-piece 750 ml shaker, copper outside and steel inside, with a built-in strainer that actually seals.
Stainless Steel
A 12-inch round with a bonded rubber deck. The most-replaced item behind any bar, built to stop being replaced.
Stainless Steel
A 1.5-litre bar bucket with a perforated drain insert and matching tongs. Melt water sits below the ice, not in it.
Copper
A 1.5-litre table pitcher, hammered and lined. The piece that sits on the table for the whole meal.
Stainless Steel
A single-bottle cooler with a genuine vacuum gap between the walls. It holds temperature about twice as long as a single-wall cooler and never sweats onto linen.
Copper
A two-bottle bucket in hand-hammered copper with cast brass ring handles. The piece that goes to the table when the order is worth announcing.
Brass
A six-bottle party bath on a cast tripod stand. Floor-standing, so it takes nothing off the bar and nothing off the table.
Stainless Steel
A tableside stand that takes any of our single-bottle coolers to serving height. It removes the cooler from the table without removing it from the guest.
Brass
A 14-inch hand-hammered round with a rolled rim. The general-purpose tray a floor uses forty times a day.
Three hundred covers, one line, no cold food.
The metal a guest touches before the food arrives.
Sun, chlorine and salt air are a materials problem.
Trade enquiry
Tell us what you are specifying and we will come back with prices, MOQs and a lead time. If you already built an enquiry list, it is attached automatically.