
Stainless Steel
Square Tray, Hammered Rim
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.
In use
The metal a guest touches before the food arrives.
At a covered table the metalware is doing its work during the ten minutes before service — the charger, the napkin ring, the water pitcher. It is the room's first statement about price.
The scenario
A 60-cover restaurant setting for dinner service, white linen, low warm light.
What to specify
The pieces

Stainless Steel
A square tray with a smooth mirror well framed by a hand-hammered rim, the corners drawn gently upward. Made in two sizes.

Stainless Steel
A rectangular hand-hammered tray whose short ends draw out into shaped handles cut from the same sheet, with a raised rim on all four sides.

Stainless Steel
A long, narrow dish drawn to a point at one end and swept into a curved tail handle at the other, mirror-polished throughout. Made in two lengths.

Stainless Steel
A flat serving tray with a wide hammered rim framing a smooth mirror well, made as two ovals and a round.

Stainless Steel
A square tray worked the other way round from most: a hammered centre panel inside a smooth stepped rim.

Stainless Steel
A small narrow tray with a rolled rim and a recessed panel, photographed in two surface treatments — a fine bead and an etched scroll.

Stainless Steel
A plain round platter, mirror-polished, with a narrow rolled rim and no texture anywhere on it.

Copper
A square tray in hammered copper with a smooth rolled rim — the one piece in this set that is not silver-coloured.

Stainless Steel
A square bowl hammered all over, the four corners drawn upward into points and the sides falling away between them.

Stainless Steel
A shallow leaf-shaped dish with a raised midrib running its length and a fine combed rib radiating from it. Made in two sizes.

Stainless Steel
A shallow triangular dish with a textured well and a smooth raised edge, the corners rounded. Made in two sizes.

Stainless Steel
A long platter drawn to a point at both ends, with a recessed textured well and the edges sweeping up and away.

Stainless Steel
A deep oval dish with a domed hammered lid seated on a wide flat rim, the base left smooth.

Stainless Steel
A square covered dish, hammered on both base and lid, with a fine beaded moulding running around the rim of each.

Stainless Steel
A plain round charger with a brushed face and a narrow plain rim — no texture, no pattern, no applied edge.

Stainless Steel
A charger with a smooth mirror well framed by a rim worked in fine lines radiating out to the edge.
Stainless Steel
A beaded-rim charger, silver-plated over steel rather than over brass — so a scratch shows steel, not yellow.
Brass
A charger masked and plated in two tones — a brass rim around a nickel well, or the reverse. One plate that works with both warm and cool tableware.
Copper
A three-piece 750 ml shaker, copper outside and steel inside, with a built-in strainer that actually seals.
Copper
A 1.5-litre table pitcher, hammered and lined. The piece that sits on the table for the whole meal.
Stainless Steel
A single-bottle cooler with a genuine vacuum gap between the walls. It holds temperature about twice as long as a single-wall cooler and never sweats onto linen.
Copper
A two-bottle bucket in hand-hammered copper with cast brass ring handles. The piece that goes to the table when the order is worth announcing.
Stainless Steel
A tableside stand that takes any of our single-bottle coolers to serving height. It removes the cooler from the table without removing it from the guest.
Brass
A 14-inch hand-hammered round with a rolled rim. The general-purpose tray a floor uses forty times a day.
Copper
An 18-inch oval for a whole roast, a whole fish, or a mezze spread. Steel-faced, copper-backed.
Brass
A traditional gallery tray with a pierced and embossed rim, for lobby, turndown and welcome service.
Brass
A 13-inch hammered charger in antique brass. Thirteen inches of worked metal is the cheapest way a banquet hall doubles its apparent price.
Copper
A plain, unhammered copper charger. The quietest plate we make and the one that photographs best under warm light.
Stainless Steel
A 500 ml sauce boat with a drip-free lip and an underplate. It pours clean or it is not finished.
Three hundred covers, one line, no cold food.
Sun, chlorine and salt air are a materials problem.
It travels a corridor, a lift and a threshold.
Trade enquiry
Tell us what you are specifying and we will come back with prices, MOQs and a lead time. If you already built an enquiry list, it is attached automatically.